Sub-Zero CT30G - Manual (Page 11)

Surface Burners
SEALED BURNER ASSEMBLY
The unique dual-stacked, sealed burner design of your
gas cooktop combines all of the burner parts in one
assembly.
After cleaning or removing burner parts for any reason, it
is extremely important that you reassemble burners
correctly.
The burner cap has a groove in the bottom, which allows
the cap to fall into place when moved around the top of
the burner. The cap should be flat relative to the burner
when in the proper orientation. Failure to do this will result
in a poor flame. Refer to the illustration below.
Failure to position the burner parts correctly could
cause flames or gas to escape and burn between
parts, resulting in poor combustion or damage to the
cooktop.
Gas Cooktop Operation 11
wolfappliance.com
BURNER
CAP
IGNITER
SEALED BURNER
Burner assembly. Surface burner on HIGH. Manual lighting
FLAME HEIGHT AND APPEARANCE
Select a flame that is just high enough to maintain the
desired cooking speed and is sized to fit the base
diameter of the pan. Never extend the flame beyond the
base of the pan. Refer to the illustration below.
A natural gas flame should be blue with a deeper blue
core. There should be minimal trace of a yellow flame.
A yellow flame indicates an improper mixture of air and
gas or impurities in the gas supply to the cooktop. If this
occurs consistently, call Wolf factory certified service to
adjust the mixture. With LP gas, some yellow tipping
to the flame is acceptable and may not require an
adjustment.
MANUAL LIGHTING
In case of a power outage, you can relight the surface
burners manually. Turn the control knob to HIGH, then
light the burner using a BBQ lighter. Refer to the illustra-
tion below.