Skylink AA-433 - Manual (Page 5)

– 4 –
INSTALLATION
Installation is done using the screws included. For your convenience, we have
also included wall anchors and a template to aid in the installation of the Audio
Alarm.
How to use the template to help in the installation:
1. Tape the template to the wall where you would like the Audio Alarm to be
2. Screw part way into the surface where the holes are marked on the template
3. Unscrew the screws and remove the template
4. Screw the Audio Alarm in place where you started the screws
We recommend that you install the Audio Alarm first with the double sided tape
included and once you are satisfied with the positioning, reinstall using the
screws.
INSTALLING THE AUDIO ALARM
The Audio Alarm is water resistance so it can be installed indoors or outdoors
within access to an electrical outlet. Be careful that the AC adapter wire doesn't
guide rain water to the DC JACK located at the bottom of the Audio Alarm.
There are two ways to attach the Audio Alarm to the wall:
Hanging it on two stationary screws
1. Using the template provided, insert the two
screws into the wall.
2. Align the two top keyholes on the triangular
tabs located at the back of the Audio Alarm
with the screws on the wall.
3. Gently push the Audio Alarm on to these
two screws.
4. Open the small door on the bottom of the
Audio Alarm.
5. Insert the AC adapter and the antenna in the
appropriate holes.
6. Close the small door so that the AC adapter
and the antenna are running through the
appropriate spaces in the door.
– 11 –
BATTERY MAINTENANCE
Audio Alarm Battery
The Audio Alarm comes equipped with a 9 volt alkaline back up battery in case the
electrical power is interrupted for any reason.
When the Audio Alarm battery is low, the “LO BATT” light goes on.
To replace the Audio Alarm backup battery:
1. Take the Audio Alarm off the wall.
2. Turn off the unit and remove the AC adapter.
3. Remove the six screws then take off the back
cover.
4. Disconnect old battery.
5. Connect new battery.
6. Replace the back cover and install the six
screws.
The battery life, (9 volt alkaline battery), is approximately two years if only used
for backup.