Sangean DDR-22 User Manual

Page 13

Operation radio

Note:
other than the volume control and standby on/off. All the operation of
this receiver is via supplied remote control unit.

Operating your radio – DAB

1. Fully extend the telescopic aerial.

2. Press the Standby button to switch on your radio then press DAB.
Display will show “Welcome to Digital Radio“ for a few seconds.

3. If this is the first time the radio is used, a quick scan of DAB
channels will be carried out. The display will show “scanning“.
If the radio has been used before, the last used station will
be selected.

4. During the scanning, as each group of stations is detected,
the bottom line of the display will show the stations count.
The top line of the display shows a bar graph indicating progress
of the Scanning .

5. When the Scanning is completed, the first station will be selected.

6. If the station list is still empty after Scanning, your radio will display
“Station not available“.

7. If no signals are found, it may be necessary to relocate your radio
to the position giving better reception.

DDR-22_381P101_GB.p65

2006/3/23, ¤W¤И 09:49