Smeg A1AU6 - Manual (Page 3)

Important Safety Instruction
5
NOTE: This range is manufactured for use with Natural gas. To convert to LP/Propane gas, see
instructions in the Gas Conversion Kit provided in the literature package.
A proper gas supply connection must be available. See "Gas supply requirements”.
In the State of Massachussetts, the following installation instructions apply:
- Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter
qualified or licensed by the State of Massachussetts.
- If using a ball valve, it shall be the T-handle type.
- A flexible gas connector, when used, must not exceed 3 feet.
WARNING
- All ranges can tip
- Injury to persons could result
- Install anti-tip device packed with the range
- See installation instructions
FAILURE TO FOLLOW THESE INSTRUCTIONS CAN RESULT IN DEATH OR
SERIOUS BURNS TO CHILDREN OR ADULTS.
NOTE: This range is NOT designed for installation in manufactured (mobile) homes or for installation in
recreational park trailers.
DO NOT install this range outdoors.
WARNING
To reduce the risk of fire, electrical shock, injury to persons, or damage
when installing the range, some basic precautions must be followed,
including:
- Read all instructions
- Proper installation is your responsibility. Have a qualified technician install and ground this appliance,
in accordance with these installation instructions.
- It is the responsibility of the installer to comply with the installation clearances specified on the
model/serial ID plate. This plate is visibly positioned in the oven door frame and must not be
removed.
CAUTION: To eliminate the risk of burns or fire caused by reaching over heated surface units, cabinet
storage located above the surface unit should be avoided.
- ELECTRICAL GROUNDING REQUIRED: See the “Electrical Connection” section. It is the
customer’s responsibility:
1 To contact a qualified electrician to install the appliance
2 To ensure that the electrical system is adequate and in conformance with the national ANSI /
NFPA 70 ELECTRICAL CODE – Latest edition – Or the CSA STANDARDS C22.1-94,
CANADIAN ELECTRICAL CODE, PART 1 AND CSA C22.2 No. O-91 – or latest edition – and all
local codes and ordinances. IMPORTANT: Observe all governing codes and ordinances.
- Before you plug in the electrical cord, make sure that all the controls are in the OFF position.
- Never modify or alter the construction of the appliance. For example, do not remove leveling legs,
panels, wire or anti-tip brackets/screws.