SUPER MICRO Computer H8QMI-2 - Manual (Page 11)

Chapter 1: Introduction
1-5
H8QM3-2/H8QMi-2 Quick Reference
Jumpers Description Default Setting
JBT1 CMOS Clear (See Section 2-7)
JCF1 Compact Flash Card Master/Slave Closed (Master)
JPS1* SAS RAID Select Closed (SR RAID)
JPX1A PCI-X Slot Speed Select Pins 2-3 (133 MHz)
JPX2A PCI-X Slot Speed Select Open (Disabled)
JI 2 C1/JI 2 C2 I 2 C to PCI-X Pins 2-3 (Disabled)
JI 2 C3/JI 2 C4 I 2 C to PCI-E Pins 2-3 (Disabled)
JPG1 VGA Enable/Disable Pins 1-2 (Enabled)
JPL1 JLAN Enable/Disable Pins 1-2 (Enabled)
JWD Watch Dog Pins 1-2 (Reset)
Connectors Description
3-SGPIO1/3-SGPIO2* SGPIO Headers (used with SAS)
COM1/COM2 COM1 Serial Port/Header
FAN 1-9 Chassis/CPU Fan Headers
Floppy Floppy Disk Drive Connector
I Button* I Button (for RAID 5 support)
IDE IDE Drive/Compact Flash Card Connector
J1B1 24-Pin ATX Power Connector
JD1 Onboard Speaker/Power LED
JF1 Front Panel Connector
JL1 Chassis Intrusion Header
JLAN1/2 Gigabit Ethernet (RJ45) Ports
JOH1 Overheat Warning Header
JPI 2 C I 2 C Header
JPW1/JPW2 8-Pin Processor Power Connectors
JWF1 Compact Flash Card Power Connector
JWOL Wake-On-LAN Header
JWOR Wake-On-Ring Header
SAS0 ~ SAS7* Serial Attached SCSI (SAS) Ports
SATA0 ~ 5 Serial ATA (SATA) Ports
T-SGPIO1/T-SGPIO2 SGPIO Headers (used with SATA)
SIMLC IPMI 2.0 (with virtual media over LAN) Slot
USB0/1 Universal Serial Bus (USB) Ports
USB2/3 USB Headers
*H8QM3-2 only