Seagate Server - Manual (Page 136)

Mirra Manual for Windows Release 2.2 128
You must wait until your Personal Server is completely shut down before
disconnecting power. If you disconnect power while it’s running or while it’s in the
process of shutting down, your backed up files can become corrupted. Wait until
both lights beside the power button are off before disconnecting power.
If you hold down the power button for longer than four seconds or pull out the power
plug before you shut down the Personal Server, the next time you launch the Mirra
software, you see a popup warning in the System Tray:
Figure 9~3 Improper Shutdown Warning
Returning to Factory Defaults
Caution: Read the follows instructions carefully before you begin your factory
reset.
To erase the contents of your Personal Server and return all settings to the
factory defaults,
Step 1: If possible, use your Mirra desktop application to remove all backups from
your Personal Server.
Step 2: Use Add/Remove Programs to uninstall the Mirra PC software from your
computer.
Step 3: Press the power button in the following sequence while your Personal Server
is running:
(a) Press the power button three (3) times in quick succession.
Although a beep follows each button press, the beeps usually occur more
slowly than the button presses. Do not slow down your button presses to
wait for the beeps. Press the button rapidly 3 times.
(b) After you’ve pressed the button for the third time, wait 10 to 15 seconds
until the Personal Server beeps quickly 3 times in succession and the
amber light flashes 3 times.
(c) Again press the power button 3 times.