SOYO SY-6IWM User Manual
Page 50
Hardware Installation
SY-6IWM
46
2-3.6 Power On
You have now completed the hardware installation of your Motherboard
successfully.
1. Turn the power on
2. To enter the BIOS Setup Utility, press the key while the system is
performing the diagnostic checks,
Note: If you have failed to enter the BIOS, wait until the boot up sequence
is completed. Then push the RESET button and press key again at
the beginning of boot-up, during diagnostic checks.
Repeat this operation until you get the following screen.
3. The BIOS Setup screen appears:
CMOS Setup Utility – Copyright ( C ) 1984-1999 Award Software
4Soyo Combo Feature
4PC Health Status
4Standard CMOS Features
Load Optimized Defaults
4Advanced BIOS Features
Load Fail - Safe Defaults
4Advanced Chipset Features
Set Supervisor Password
4Integrated Peripherals
Set User Password
4Power Management Setup
Save & Exit Setup
4PnP/PCI Configurations
Exit Without Saving
Esc : Quit
бваЯ : Select Item
F10 : Save & Exit Setup
Change CPU’s Clock & Voltage