Woodstock W1683 - Manual (Page 16)

12
Switch
Figure 6. Attaching switch to the planer.
Figure 7. Knife setting jig.
The prewired magnetic switch needs to be
mounted to the planer head casting.
To mount the switch:
1. Match the holes at the back of the switch
with the tapped holes in the front, left-
hand corner of the planer.
2. Secure the switch to the head casting with
the cap screws as shown in Figure 6.
3. Read Section 2: Circuit Requirements in this
manual, then install an appropriate plug to
the power wire.
Knife Setting Jig
We have provided a jig to make the knife setting
process easy and quick. Please refer to Figure 7
for jig component identification while
assembling.
To assemble the knife setting jig:
1. Snap one of the E-clips over the notch on
one end of the knife setting rod.
2. Slide the aluminum knife setting jig
brackets onto the rod.
3. Snap the other E-clip on the other end of
the knife setting rod.
Refer to page 17 for use.
DO NOT connect machine
to the power at this time!
Wait until all other
assembly instructions and
adjustments have been
completed.