ScyTek Electronics PRECISION PRO 5500 - Manual (Page 18)

2-way LCD Remote Transmitter Description
The Precision 5500 and 2200 are supplied with a 2-way LCD remote transmitter, offering increased range
and confirmation of any activated features.
Page 1
Button 1 Arms* and Locks the system and when held for 5 seconds, activates the system’s Panic feature.
Button 1 also locks the doors when the system is in Valet Mode.
Button 2 Disarms* and Unlocks the system. Pressing Button 2 again operates the Passenger Unlock feature
(if installed). Button 2 also unlocks the doors when the system is in Valet Mode.
Button 3 Activates the Auxiliary 1 output normally used for trunk release (note trunk icon on button).
Button 4 Activates the Remote Start feature.
Button 5 is the Confirmation, Programming and the Page Shift button. Quickly pressing button 5 will activate
the Page 2 function. Pressing button 5 for 2 seconds activates the system’s confirmation feature which will
then display the current status of the system (armed, disarmed, engine running, etc.).
Page 2
Button 1 Silently Arms*/Locks the system.
Button 2 Silently Disarms*/Unlocks the system.
Button 3 Activates the Auxiliary 2 output.
Button 4 Aux 3 or Factory Rearm output.
Button 5 Not Implemented.
Page 3 & 4 are used as Page 1 & 2 for second car operation
Adding/Replacing 2-way LCD Transmitters
When adding a 2-way LCD transmitter to the system ( maximun of two LCD Transmitters total) Any
previously stored transmitter will be erased if it is not programed within the following sequence.
follow these steps:
1. Turn the ignition key On, Off, On, Off, On, Off, and back On. (Key On 4 times)
· 3 seconds Later the siren*/horn will chirp/honk 4 times.
2. Press and hold the Override switch for 5 seconds .
· The siren*/horn will chirp/honk 4 times.
· The LED will illuminate.
Button 1 Button 2
Button 3
Button 4
Button 5
Page 14 - Precision