StarTech.com SV421DD - Manual (Page 5)

3
Using Your KVM Switch
There are two ways to access your connected computers: the front panel pushbutton or a
hotkey sequence.
Using the Pushbutton
Pressing the pushbutton on the front of the KVM switch allows you to scroll through your
computers sequentially.
Using the Hotkey Commands
A keyboard hotkey sequence consists of three keystrokes. Each hotkey sequence starts
with two Scroll Lock keystrokes. You must strike the Scroll Lock key twice in two
seconds or less in order for the hotkey sequence to be acknowledged.
T Trro ou ub blle es sh ho oo ottiin ng g
Keyboard/mouse problems
• You should have connected your keyboard, mouse, and monitor to the KVM switch
before connecting the switch to your computer. If you reversed this process, try
rebooting your PCs.
• Make sure the mouse/keyboard are properly connected to the KVM switch and that
you have installed the proper drivers for your mouse/keyboard.
• Try rebooting your KVM switch by pressing ScrLk + ScrLk + End.
• If your keyboard/mouse came unplugged while in operation, you may need to
reboot your PCs in order to get the switch to recognize your keyboard/mouse again.
C o m m a n d Hotkey Sequence Description
Select PC ScrLk + ScrLk + 1 (2, 3, 4)
Selects the PC plugged
into Port 1 (2, 3, 4)
Next lower PC ScrLk + ScrLk + Up
Selects the next (lower)
PC.
Next higher PC ScrLk + ScrLk + Down
Selects the next (higher)
PC.
Start Autoscan ScrLk + ScrLk + S
Starts autoscan mode. You
can quit autoscan mode by
pressing any key
Autoscan Beep ScrLk + ScrLk + B
Toggles on/off the
confirmation beep while in
autoscan mode.