Sony CMT-L1 - Manual (Page 20)

20 GB
Using the display
Checking the remaining time
Press TIME on the remote repeatedly
during playback.
The display changes cyclically as follows:
Elapsed playing time on the current track t
Remaining time on the current track* 1 t
Remaining time on the current CD* 2
* 1 “--.--” appears when you check the remaining time
of a CD track whose number is 21 or over.
* 2 “--.--” appears during Shuffle Play of a CD which
has 21 or more tracks, or during Program Play
when a CD track whose number is 21 or over is
selected.
Checking the total playing
time
Press TIME on the remote in stop mode.
Checking a track title, a disc
title (CD)
Press DISPLAY repeatedly.
The CD display changes cyclically as follows:
Clock display* 1 t Preset Equalizer name* 1
t Volume* 1 t Playing time of the CD* 2 t
Track title or disc title* 3
* 1 After 8 seconds, the playing time of the CD
appears.
* 2 The display that appears depends on the current
disc status:
If the disc is stopped: The total playing time of the
CD is displayed.
If the disc is playing: The elapsed playing time of
the track, remaining playing time of the track, or
remaining playing time of the CD is displayed.
* 3 The track title appears during playback (only for
CDs with CD text), and the disc title appears when
the disc is stopped. If a CD that has no title, the
track title or disc title is skipped.
Display
Turning off the display
— Power Saving Mode
Even if the system is off, the system consumes
power to display the clock and to stay
responsive to commands from the remote.
Power Saving mode reduces the amount of
power consumed during standby.
In this mode, the clock is not displayed.
Press DISPLAY or TIME on the remote
while the system is off until the the clock
display disappears.
To cancel Power Saving mode
Press DISPLAY or TIME on the remote while
the system is off.
The display changes as follows:
Clock display* y No display (Power Saving
mode)
* The clock is displayed only if you set the clock.
Tip
The timer continues to operate during Power Saving
mode.
Changing the illumination
level
You can change the illumination level for the
front panel.
Press DIMMER on the remote repeatedly.
The illumination level changes cyclically as
follows:
High t Low t Off
Tip
The illumination level is factory set to high.