Spirit XT385 - Manual (Page 12)

XT385/XT485 11
STEP 2
1. Mount the L&R Handle bars (7A & 7B) onto Handle bar mounting plates at the top of the
upright tubes with four 5/16” x 2” Button Head Socket Bolts (134) and four curved washers
(140). NOTE: The L&R handlebars are different. The Right handle bar has two wires
and the switches on the handle bar say “Fast and Slow” while the Left handle bar
switch says “Up and Down”.
STEP 3
1. Install the L & R inside console end caps (68 left, 69 right) onto the ends of the 1-1/4” X
2-3/8” console mounting tube. Ensure the end caps are oriented correctly and facing the
correct direction (see diagram). Also ensure that the wiring is fed through the end caps.
2. Place the console onto the L & R mounting brackets at the top of the upright tubes. Then
install and hand tighten the two 5/16” x 2-3/4” Hex Head bolts (137) and flat washers (145)
through the holes in the top and front of the console mounting tube.