Trouble-shooting guide – Sebo Automatic X5 User Manual
Page 10
Page 10
PROBLEM
Does not turn on
or machine shuts off
intermittently
Bag full or clog light on
or flashing &
machine shuts off
Brush light on
Brush light slowly
flashing
Brush light flashing &
machine shuts off
Up & down lights flicker
Does not pick up
Front bag door won’t
fully close
Hose doesn’t retract
after attachment tube is
inserted
REASON
1. Handle not fully inserted into the bag
housing, causing a faulty connection.
2. Not plugged into good outlet.
3. Cable worn.
4. Dust bag housing (6) not seated
fully into proper “locked” position
on top of power head.
1. Bag full.
2. Clog in airflow pathway, attach-
ment hose, attachment tube, swivel
neck or entrance to dust bag.
3. Microfilter dirty.
1. Brush worn.
1. Vacuum is stationary and in
upright locked position.
1. Brush jammed.
1. Operating on uneven floor.
1. Attachment tube not
correctly inserted.
2. Front cover not closed.
1. Cover release flap not fully closed.
2. Bag not inserted properly
3. Microfilter not properly inserted.
1. Attachment tube not properly
inserted.
SOLUTION
1. Release handle catch, push handle
down, close handle catch.
2. Use another outlet.
3. Replace cable.
4. Housing release button (8) should
be snapped outward to its locked
position.
1. Replace bag. See #5 on page 4.
2. See Clog Removal on page 9.
Also, see #5 on page 4.
3. Replace microfilter.
1. See #3 on page 4.
1. See #4 on page 4.
1. See #2 on page 4.
1. Ignore.
1. Reinsert attachment tube, making
sure lower end of tube is in the
lower hole and handle is properly
seated over the projection tab (22).
2. See below.
1. Reinsert bag. Lock the cover
release flap down firmly.
2. Reinsert bag with cover release
flap (5) up, until firmly latched in
bag holder (see pg. 8, figure 7).
3. Lift safety lever and insert filter with
vertical plastic ridge on filter facing
you (see pg. 8, figure 8).
1. Reinsert making sure top of handle
is pointing back and tube is fully
seated on the protruding tab (22)
on top of the dust bag housing.
Trouble-Shooting Guide
Always unplug vacuum from outlet before dismantling any part of the machine!
!