Sony Ericsson CDP-CX220 - Manual (Page 16)

– 16 –
cam
cam
bracket (sensor)
lever (stopper) ass’y
table ass’y
lever (stopper) ass’y
disc table
swing
tapering screwdriver
LUMINOUS board
bracket (sensor)
PLAY button PAUSE button
fixed screw
(2) Check that the lever (stopper) ass’y secures
the disc table as shown in the figure.
(1) Rotate the cam and adjust to the position
shown in the figure.
(3) Loosen the fixed screw by 60 ° to 90 ° , and use a tapering screwdriver to adjust the screw as shown in the figure.
Move the bracket (sensor) with the tapering screwdriver little by little, and fix the fixed screw at where the play button's LED (green)
is switched to the pause button's LED (orange) (or its reverse).
SENSOR ALIGNMENT
Perform this adjustment after the “holder (disc A2) adjustment”.
If the disc table swings to the left and right just before the disc is
chucked, perform the following adjustment.
(4) Moving the disc table right and left with a hand after the
screw is fixed, the table will move by the play of a disc table.
If the LEDs light up alternately, the adjustment will be per-
formed correctly.