Specifica, Specification helpful hints, Specification – Sanyo CE32LM4WPR-E User Manual
Page 12
12
Common specification
Power source 220~240V 50Hz
Television system
System I B/G, D/K, L’L
Colour system
PAL (PAL/NTSC3.58 in AV mode),SECAM
Channel coverage
UHF: 21-69,
VHF: E2-E12,F2-F10,R1-R12
CATV: X, Y, S1 -S41, B-Q
Aerial input impedance
75 ohm
AV terminal
AV1: CENELEC Standard
Input: Composite video, RGB and audio-L/R
Output: TV-output with composite video and audio-L/R
AV2: BNC
Input: RGB, H and V / Y, Pb, Pr audio-L/R
Output: RGB, H and V / Y, Pb, Pr
AV3: BNC
Input: Composite video
Output: Composite video
Audio M.Out: CINCH L/R
HDMI
Input :
HDMI GROUP Standard
PC Input
Serial port RS232C: Input/ output
CE32LM4WPR-E
Contrast Ratio
1000:1
Screen(inches/ cm)
32” / 81 cm
(viewing measured
diagonally)
Display Resolution
1366 X 768 (WXGA)
Viewing angles
H:176°, V:176°
Dimensions (WxHxDmm) 803X493X162
Weight (kg)
21.8
■
NO PICTURE
●
Check if monitor is plugged in.
●
Try a different channel, if OK, probably station trouble.
■
POOR PICTURE
●
Adjust BRIGHTNESS control.
●
Adjust FINE TUNING control.
●
Check aerial connections.
■
NO COLOUR, PICTURE OK
●
Adjust COLOUR control.
●
Adjust FINE TUNING control.
●
Is the programme in colour ?
■
WEAK PICTURE
●
Check aerial connections on back of set.
●
Check aerial for broken wires.
●
Re-orient aerial.
The following faults are not caused by the receiver:
"GHOSTS"
Reflections of signals from mountains or high buildings will cause
multiple images, called "Ghosts". These abnormal conditions can be
reduced to minimum by repositioning aerial or by installing new one
suited for your area.
"INTERFERENCE"
Interference may be caused by electrical appliances, car ignition
systems, etc. This should normally be a temporary condition, but
should this interference persist, contact your dealer.
This LCD monitor set allows you to set up the following:-
■
Prohibition of presetting.
This prohibits the use of tuning.
■
Programme position at Start up
SETTING PROCEDURE
1 . Press and hold the green button on the remote control
handset for 5 seconds.
2. Use the
5
or
6
button to highlight Hotel Mode, use the
1
to switch ON or OFF.
3.
Select ON program using the
6
button, select the start up
position using the
1
or
2
buttons.
(AV2 - AV1 - 0 - 1 - 2 - 3 - 4 ........99)
4. Press the MENU button to exit from the menu.
SPECIFICA
SPECIFICA
TIONS / HELPFUL
TIONS / HELPFUL
HINTS / HOTEL
HINTS / HOTEL
MODE
MODE
GB
GB
Specification
Helpful hints
MENU
Hotel mode
ON / OFF
On program OFF/ 1~99
Preset ON / OFF
Address
007
Baud
Rate
19200
/ AV1-AV3 /RGB/ HDMI/ PC
Hotel
: Select
: Adjust
: Exit
Specification