Installation step 2, Installation and mounting, Amplifier location – Soundstream Technologies 501 User Manual
Page 13: Mounting the amplifier, Wiring, Power up
13
INSTALLATION STEP 2
AMPLIFIER LOCATION
The RUBICON amplifiers employ highly efficient circuitry, a custom-engineered
heat sink, and a unique Chassisink construction to maintain lower operating
temperatures. Additional cooling may be required if the amplifier is located in a
tightly confined area or when driving especially low impedance loads at extremely
high levels.
When mounting the amplifier, it should be securely mounted to either a panel in
the vehicle or an amp board or rack that is securely mounted to the vehicle. The
mounting location should be either in the passenger compartment or in the trunk
of the vehicle, away from moisture, stray or moving objects, and major electrical
components. To provide adequate ventilation, mount the amplifier so that there
are at least two inches of freely circulating air above and to the sides of it.
MOUNTING THE AMPLIFIER
a. Using the amplifier as a template, mark the holes on the mounting surface.
b. Remove the amplifier and drill the holes for the mounting screws.
c. Secure the amplifier to the mounting surface using the supplied hardware.
WIRING
a. Run and connect the audio signal and remote turn-on cables to the ampli-
fier from the source unit.
b. Carefully run the positive cable from the amplifier to a fuse or circuit breaker
within 18” of the battery.
c. Connect the fuse or circuit breaker lead to the battery. Leave the circuit
breaker off or the fuse out until everything is bolted down.
d. Secure the ground cable to a solid chassis ground on the vehicle. It may be
necessary to sand paint down to raw metal for a good connection.
e. Double check each and every connection!
f. Re-connect the fuse or circuit breaker.
POWER UP
Power up the system, there may be a 2-3 second delay from the time the source
unit is turned on to the time that the amplifier turns on, which is normal. Once the
amplifier LED is on and the source unit is playing, you should have sound coming
from the speakers.
INSTALLATION AND MOUNTING