Sears 200.71219 - Manual (Page 8)

8
1.. Note.the.polarity.of.the.battery.posts.
by checking the identification marks
on the battery: POSITIVE (POS, P
or +) and NEGATIVE (NEG, N or -).
The.positive.post.is.usually.larger.
than.the.negative.post.
2.. Attach.at.least.a.24-inch-long,.6-
gauge (AWG), insulated battery ca-
ble to NEGATIVE (NEG, N or -) bat-
tery.post..Rock.and.twist.the.clamp.
back.and.forth.to.be.sure.a.solid.
electrical.connection.is.made.
3. Connect the red (POSITIVE) output
clamp.to.the.POSITIVE.battery.post..
Rock.and.twist.the.clamp.back.and.
forth.to.be.sure.a.solid.electrical.con-
nection.is.made.
POSITIvE NEgATIvE
BATTERy ChARgER
BATTERy
24", 6 gAUgE
CABLE
POWER
CORD
TO
gROUNDED
POWER
OUTLET
ChARgINg BATTERy REMOvED
FROM ThE vEhICLE:
4.. Position.yourself.as.far.away.from.
the.battery.as.possible,.and.then.
connect the black (NEGATIVE)
output.clamp.to.the.free.end.of.the.
cable.
5.. Select.the.desired.charge.rate.and.
battery.type:.2A,.12V.or.4A,.6V.
6.. Plug.the.power.cord.into.an.AC.110V.
electrical.wall.outlet..
7.. Press.the.appropriate.control.buttons.
to.select.the.desired.charge.rate.
and.battery.type..The.CHARGING.
(yellow) LED should light and the
charging.process.should.start..If.the.
CHECK (red) LED is on, check for
correct.cable.connections.
8.. To.disconnect.the.charger,.unplug.
its.power.cord.before.attempting.
to.disconnect.the.charger.clamps..
Then,.standing.away.from.the.bat-
tery,.remove.the.output.clamp.from.
the.NEGATIVE.battery.post..Finally,.
remove.the.output.clamp.from.the.
POSITIVE.battery.post.
9.. Clean.and.store.the.charger.in.a.dry.
location.
IMPORTANT:.Follow.all.safety.instruc-
tions.and.precautions.when.charging.
your.battery..Wear.complete.eye.protec-
tion.and.clothing.protection..Charge.your.
battery.in.a.well-ventilated.area.