SIIG 04-0589A User Manual

Page 4

Slide the Dual 2.5" SATA MobileRack into the drive

bay and secure it on each side using the mounting

screws.

Connect a power cable to the power connector that

is matched with your system's power supply or use

the supplied power adapter cable.

Connect one end of the Serial ATA cable to the Dual

2.5" SATA MobileRack and the other end to the

motherboard SATA port. Please repeat these steps

if you are installing the second hard drive.

Close your computer case.

Installing the Hard Drive into the MobileRack

Unlock upper and lower covers, then open the

door (see Figure 3 on the next page).
Note: Do not force the door to open while it is

locked. Otherwise, you will damage the lock.

Place one or two hard drive(s) in the slot. Make sure

the SATA connector is lined up with the connector

inside the MobileRack.

Carefully push the hard drive into the MobileRack

so that the drive's SATA connector is seated securely,

then close the door and lock it.

Note: It must be in the lock position when in use.

This prevents unexpected removal while working.