SINGER ESP 2 - Manual (Page 8)

7.Replace Water Reservoir Cap and push filled Water Reservoir back into main unit. 7.Replace Water Reservoir Cap and push filled Water Reservoir back into main unit.
OPERATION INSTRUCTIONS OPERATION INSTRUCTIONS
1.Turn the ON/OFF Switch to the"on"position. 1.Turn the ON/OFF Switch to the"on"position.
2.Identify the type of fabric you will press and then select the temperature
setting that matches the fabric to be pressed. It is best to start with the most
delicate fabrics first, as higher heat will cause damage to Nylon and Silks. 2.Identify the type of fabric you will press and then select the temperature
setting that matches the fabric to be pressed. It is best to start with the most
delicate fabrics first, as higher heat will cause damage to Nylon and Silks.
3.Lay fabric flat on Ironing Board. 3.Lay fabric flat on Ironing Board.
4.Digital Fabric Steam Press is ready for use when Pressing Indicator Light
deactivates. If pressing wool, you may choose to spray with a burst of steam.
This function is available once Steam Burst Ready Indicator Light illuminates. 4.Digital Fabric Steam Press is ready for use when Pressing Indicator Light
deactivates. If pressing wool, you may choose to spray with a burst of steam.
This function is available once Steam Burst Ready Indicator Light illuminates.
NOTE: Do not activate burst of steam with unit completely closed, as this may
damage unit. Best results are obtained if Pressing Plate is held open approxi-
mately 75 mm above Ironing Board before pressing Steam Button. For safety
reasons, do not hold Pressing Plate open more than 75 mm when using steam
burst function. NOTE: Do not activate burst of steam with unit completely closed, as this may
damage unit. Best results are obtained if Pressing Plate is held open approxi-
mately 75 mm above Ironing Board before pressing Steam Button. For safety
reasons, do not hold Pressing Plate open more than 75 mm when using steam
burst function.
5.To press, lower Pressing Plate gently onto fabric and Ironing Board. Hold there for 6-8 seconds, then
lift up Pressing Plate. Repeat until you have achieved desired crease and smoothness.
5.To press, lower Pressing Plate gently onto fabric and Ironing Board. Hold there for 6-8 seconds, then
lift up Pressing Plate. Repeat until you have achieved desired crease and smoothness.
6.Once Pressing tasks are complete, immediately set On/Off Switch to "off"position.
6.Once Pressing tasks are complete, immediately set On/Off Switch to "off"position.
*DO NOT ATTEMPT TO PULL WATER RESERVOIR OUT COMPLETELY. *DO NOT ATTEMPT TO PULL WATER RESERVOIR OUT COMPLETELY.
7 7
OPERATION INSTRUCTIONS OPERATION INSTRUCTIONS