Smeg SLB12SB User Manual
Page 5
,167$//$7,21 ,16758&7,216
,PSRUWDQW
7KH DSSOLDQFH PXVW EH LQVWDOOHG E\ D VSHFLDOLVHG WHFKQLFLDQ DFFRUGLQJ WR FXUUHQW UHJXODWLRQV
7KH ZDVKLQJ PDFKLQH LV YHU\ KHDY\ 7DNH FDUH ZKHQ OLIWLQJ LW
813$&.,1*
The inside of the machine comprises a moving assembly which is blocked for transport purposes by the screws
(
$
located at the rear of the washing machine.
1. Release the assembly by removing these screws with a 13 mm wrench.
2. Remove the screws (
$
and relative spacers (
%
from the back of the washing machine.
3. To prevent water from entering the machine or people from touching live components with their fingers,
FORVH
WKH IRXU KROHV OHIW RSHQ E\ WKH VFUHZV ZLWK WKH VXSSOLHG SODVWLF SOXJV &
$WWHQWLRQ
•
Do not turn the machine upside down and do not place it on its side.
•
Keep all the components used to block the drum assembly as they will be needed if you decide to move the
appliance in future.
326,7,21,1* $1' /(9(//,1*
1.
Place the appliance in the
required position.
2.
Carefully level the machine
in all directions using a spirit
level and adjusting the
height of the feet if neces-
sary. After adjusting the
machine, lock the feet with
the relative lock nuts.
The water inlet and drain hoses can be turned to the right or left depending on installation requirements.
$WWHQWLRQ
•
&DUU\ RXW WKLV RSHUDWLRQ FDUHIXOO\ WR SUHYHQW WKH ZDVKLQJ PDFKLQH IURP YLEUDWLQJ JHQHUDWLQJ QRLVH RU
PRYLQJ GXULQJ RSHUDWLRQ
•
,I WKH DSSOLDQFH LV LQVWDOOHG RQ D FDUSHWHG IORRU HQVXUH WKDW WKH RSHQLQJV RQ LWV XQGHUVLGH DUH QRW RE
VWUXFWHG
•
Make sure the washing machine does not touch walls, furniture, etc., while it is working.
•
The appliance must not be installed behind a lockable door, or sliding door, or a door with hinge on the oppo-
site side to the tumble dryer