Smeg WM62141 - Manual (Page 25)

187348
5
Failure Possible cause Remedy
The machine does not
work (indicator LED’s
are not illuminated).
Machine is not powered. Check if:
• power in the socket,
• the fuse is OK,
• plug is in the socket.
Washing program
does not start
(washing stage LED is
flashing).
Door is not properly closed. Push it towards the machine.
Water does not enter
the machine (after
approx. 8 min the
machine reports
failure -3 flashes).
Disturbed water inlet. Check if:
• the water faucet is open,
• inlet pipe net filter is clean.
Push the START button.
Water is leaking from
the machine.
Filter is not tightly screwed in.
Inlet pipe is not tightly screwed
to the machine or to the water
faucet.
Outlet pipe fell to the floor.
Tighten the filter properly.
Tighten the inlet pipe.
Affix the outlet pipe to the drain.
The machine moves
during operation.
The machine is not properly
leveled.
Transport brackets are not
removed.
Level the machine with the adjustable
legs.
Remove transport brackets.
The machine vibrates
during the spin.
Unevenly distributed laundry,
especially with very small
quantities (for ex. only the
bathrobe).
This is normal, the machine will
reduce the RPM if vibrations are too
strong.
Wash larger quantity of laundry.
Excessive foaming
during washing.
Excessive measure of detergent. Use washing powder according to
the instructions by the producer and
according to the water hardness and
soiled laundry.
Use only detergents for machine
washing.
Water is poorly
pumped out or not at
all (machine reports
failure - seven flashes
of LED).
Water outlet is clogged. Check if:
• the filter is clean,
• outlet pipe is not jammed,
• outlet pipe is positioned higher than
1 m.
Push START again.
Laundry is not
properly spun.
No failure is reported.
The machine switched on the
UKS* function. Because of bad
laundry balance, the machine
has automatically reduced spin
RPM.
The machine operates normally.
Wash large and small pieces of
laundry together.