Samsung BN68-01780J-00 - Manual (Page 66)

English -
Scanning and Switching between Anynet+ Devices
1. Press the tOOLS button.
Then press the ENtER button to select "Anynet+(HDMI-
CEC)".
. Press the ▲ or ▼ button to select "Select Device", then press
the ENtER button.
. Press the ▲ or ▼ button to select to a particular device and
press the ENtER button. It is switched to the selected device.
. If you cannot find a device you want, press the ▲ or ▼ button to
select "Setup", then press the ENtER button.
. Press the ▲ or ▼ button to select "Searching Connections",
then press the ENtER button.
The message "Configuring Anynet+ connection" is displayed.
When searching devices completes, the connected devices are
listed in the Anynet+ menu.
Switching to the selected devices may take up to 2 minutes.
You cannot cancel the operation during the switching
operation.
The time required to scan for devices is determined by the number of connected devices.
When the device scan is complete, the number of found devices is not displayed.
Although the TV automatically scans devices when it is turned on using the
POWER button, devices
connected when the TV is on or under a specific circumstance are not displayed in the device list.
Therefore select "Searching Connections" menu to search devices.
If you have selected external input mode by pressing the
SOURCE button, you cannot use the
Anynet+ function. Make sure to switch to an Anynet+ device by using the tOOLS button.
➣
➣
➣
➣
➣
Setup
Anynet+ (hDMI-CEC) : On 
Auto turn Off : Yes 
Searching Connections 
Move Enter Return
View tV
Select Device 
Record 
Menu on Device 
Device Operation 
Receiver :Off 
Setup 
tV P9
Move Enter
Return
BN68-01780J.indb 64 2008-08-29 �� 11:06:51