Sunbeam 4040-026 - Manual (Page 8)

Dry Ironing
1 .
Make sure that the Steam Dial is set to ZERO.
2 . Plug the cord into a 120 volt AC outlet.
The Power Indicator will light.
3. Turn the Fabric Select Dial to the dry ironing
fabric setting you desire and allow the iron to
heat for 2 minutes. While the iron is heating,
make sure it is sitting on its heel rest on a
stable, protected surface.
Tip: Refer to the Ironing Guide on Page 15
for tbe recommended setting for your fabric.
Steam Ironing
Follow the instructions for “Filling
the Water Reservoir” on Page 5.
Plug the cord into a 120 volt AC outlet.
The Power Indicator will light.
Turn the Fabric Select Dial to the steam ironing
fabric setting you desire (Linen, Cotton, Wool
or Silk) and allow the iron to heat for 2 minutes.
While the iron is heating, make sure it is sitting
on its heel rest on a stable, protected surface.
Tip: Refer to tbe Ironing Guide on Page 15
for the recommended setting for your fabric.
After the iron has heated (2 minutes), turn
the Steam Control
desired steam setting.