Sanus Systems NF213 - Manual (Page 2)

Step 1: Attach the Cross Tubes to the Front Frame
Position the Front Frame ( A) as shown in Diagram 1; then, thread each Decorative Face Bolt (K) through the Front Frame,
a Three Hole Plate ( C) and into a Steel Cross Tube (B).
Repeat this process until all twelve Steel Cross Tubes ( B) are fastened to the Front Frame (A) as shown in Diagram 1.
Firmly hand tighten each Steel Cross Tube ( B).
Allen Bolt - I
Qty. 12
Washer - J
Qty. 4
Decorative Face Bolt - K
Qty. 12
Allen Key - M
Qty. 1
Glass Protector - L
Qty. 8
Diagram 1
A
K
C
B