Sub-Zero Built-In Refrigeration - Manual (Page 13)

13
P O W E R
All Built-In units feature a UNIT ON/OFF key
pad on the Control Center. This key pad will
turn off all electrical power to the unit. When
the power is off, the OFF indicator light will be
visible in the Control Center display panel. This
UNIT ON/OFF key pad means you don’t have
to shut off power at the circuit breaker or wall
receptacle. The key pad can be used during
service or extended vacations.
A L A R M F E A T U R E
All Built-In units have an alarm feature that will
make an audible beeping sound if the door is
left ajar.
The alarm will sound after 30 seconds. It can
be deactivated for cleaning or resupplying your
unit by depressing the "BELL" ON/OFF key
pad. When the alarm is activated, a bell symbol
will be visible in the Control Center display
panel.
I C E M A K E R C O N T R O L
All Built-In units (except Models 601R and
601RG) feature an ICE ON/OFF key pad on
the Control Center. This key pad switches the
power to the ice maker system on or off. When
the ice maker system is on, the ICE indicator
light will be illuminated in the Control Center
display panel. Use the ICE ON/OFF key pad
to shut down the ice maker during extended
vacations.
S A B B A T H M O D E ( S T A R - K )
All Built-In units feature the Sabbath Mode.
This is for certain religious observances where
the lights and ice maker function need to be
turned off.
To initiate Sabbath Mode, while the unit is on
press the UNIT ON/OFF key pad so that OFF
is visible in the Control Center display panel.
Your unit will be off.
Then press and hold the UNIT ON/OFF key
pad for 10 seconds. This will turn the unit back
on and will disable the lights and ice maker. To
return the unit to normal operating conditions,
press and release the UNIT ON/OFF key pad.
If you have questions about Star-K compliance,
visit www.star-k.org.
V I S U A L S E R V I C E D I S P L AY
The Control Center monitors refrigerator and
freezer temperatures as well as the ice maker
system. If there is a temperature or ice maker
problem, you’ll be alerted by a flashing
SERVICE indicator light. This same SERVICE
light will also flash if the condenser needs
cleaning. Before calling for service, please
check and see if your condenser area needs
cleaning. Refer to Condenser Cleaning,
page 22.
S U B - Z E R O B U I LT- I N U S E & C A R E