Siemens CMTC1720 - Manual (Page 7)

Standards and Guidelines
7
Siemens Building Technologies
Fire Safety & Security Products 10.2006
3 Standards and Guidelines
3.1 FCC Information
This equipment has been tested and found to comply with the limits for a class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following
measures:
z Reorient or relocate the receiving antenna.
z Increase the separation between the equipment and receiver.
z Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
z Consult the dealer or an experienced radio/TV technician for help.
Shielded interface cables and A.C. power cord, if any, must be used in order to
comply with emission limits.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user`s authority to operate the equipment.
3.2 CE Information
The product must be installed according to the currently valid installation
regulations for EMC to guarantee the designed use and to prevent EMC problems.
The device supplied with this manual is according to the EC, EMC Directive,
89/336/EEC & LVD 73/23/EEC Standard used for showing compliance with the
essential requirements of the device:
z EN 55022
z EN 61000-3-2
z EN 61000-3-3
z EN 50130-4
z EN 55024
z EN 60950-1