Woodstock W1694 - Manual (Page 18)

ADJUSTMENTS
-16-
Figure 20. Fence bracket assembly.
Fence Tilting
Handle
Fence Sliding
Handle
The fence assembly has two primary methods of
adjustment:
• The face of the fence is adjustable relative
to the table surface.
• The fence position is adjustable across the
width of the table.
To adjust the fence face angle relative to the
table surface, do these steps:
1. Loosen the fence tilting handle ( Figure 20).
2. Move the fence face to the desired position.
Precise angle stops will be discussed in the
Fence Angle Stops sub-section.
3. Tighten the fence tilting handle.
To adjust the fence position across the width
of the table, do these steps:
1. Loosen the fence sliding handle ( Figure 20).
2. Move the fence to the desired position
across the width of the table. The fence
position is adjustable to accommodate
workpieces of varying widths and to pro-
mote even blade usage and wear.
3. Tighten the fence sliding handle.
UNPLUG the power cord
before you do any assem-
bly or adjustment tasks!
Otherwise, serious per-
sonal injury to you or oth-
ers may occur!
Fence
ADJUSTMENTS