Simplicity 1693704 - Manual (Page 22)

Page 18
Adapted from Briggs & Stratton Corporation, Form No. 274263-10/99.
Engine is shipped from factory without oil. You
must add engine oil before starting engine.
Adapted from Briggs & Stratton Corporation, Form No. 274263-10/99.
* Air cooled engines run hotter than automotive engines. Use
of non-synthetic multi-viscosity oils (5W30, 10W-30, etc.)
above 40
ο
F (4
ο
C) will result in high oil consumption and
possible engine damage. Check oil level more frequently if
using these types of oils.
**
SAE 30 oil, if used below 40
ο F (4 ο C), will result in hard
starting and possible engine bore damage due to
inadequate lubrication.
Maintenance and Storage
CHECK OR FILL ENGINE
CRANKCASE
1. Add oil according to chart below. Do not overfill.
Use a high quality detergent oil classified "For
Service SF-SJ,". Use no special additives with
recommended oils. Do not mix oil with gasoline.
2. Always check oil level before starting engine. Refer
to engine manual for complete instructions.