Simplicity 1693704 - Manual (Page 16)

Page 12
Operation
SECTION CHECKLIST
Pre-Start Inspection
Starting and Stopping the Engine
Tilling
PRE-START INSPECTION
1. Make sure all safety guards are in place and all nuts
and bolts are secure.
2. Check oil level in engine crankcase. See your engine
manual for procedure and specifications.
3. Inspect air cleaner for cleanliness. See your engine
manual for procedure.
4. Check the fuel supply. Fill the fuel tank no closer than
1 inch from top of tank to provide space for
expansion. See your engine manual for fuel
recommendations.
5. Be sure spark plug wire is attached and spark plug is
tightened securely.
6. Check position of wheels and wheel lockouts.
7. Check drag stake position.
CAUTION
Please do not start your tiller until you have read the
Manual that came with your engine, and the sections
in this manual titled Controls, Adjustments and Safety.
If you have read these, follow the steps below to start
your tiller. Always perform this pre-start checklist
before starting the engine.
CAUTION
Gasoline is highly flammable and must be handled
with care. Never fill the tank when the engine is hot or
running. Always move outdoors to fill the tank.
CAUTION
Wheels must always be locked in the TILLING position
when engine is running. Do not operate the tiller with
the wheel lockouts unlocked. Always set the wheels
in tilling position before starting engine.
CAUTION
Always put the drag stake in the transport position
before starting engine. Tines should clear the ground.
Engine is shipped from factory without oil. YOU
MUST ADD ENGINE OIL BEFORE STARTING
ENGINE.