beautypg.com

Fig-5, Fig-4 – Sanyo LNS-M01 User Manual

Page 3

background image

INSTALL THE LENS. (See figure-4,5.)

3

1. Mount the lens at the lens

mounting bracket with screws
(4 screws) included with the
lens. Use the driver included
with the lens to fasten the
screws . (After using, save it for
latter use.)

2. Connect the lens motor lead to

the connector “K16B” of the cir-
cuit board.

3. Fasten the lens motor lead at

the A, B points with wire holder.

LENS
MOTOR LEAD

CONNECTOR “ K16B “

(D)

(D)

(D)

(D)

B

LENS MOTOR

Fig-5

This part wiring should
not be tightened.

Figure shown inside of the cabinet.

LIGHT-BLOCK SHEET

Fig-4

LENS MOUNTING BRACKET

WIRE HOLDER

ATTACHED DRIVER

MOUNT THE LENS COVER. (See figure-1)

4

When in install the both upper and lower lens covers,
put the light-block sheet through the lens and install
the sheet so that it should be placed in the guide slot
of the lens cover. If the installation of the light-block
sheet is incorrect, there will be the space between
lens and the lens cover, so that it will be the cause of
leakage of light or the dust entering at the main cab-
inet.

A