Sunbeam 2377 - Manual (Page 12)

MIXING AND BAKING SUGGESTIONS
• Ingredients should be added to the mixing bowl as they
are specified in the recipe. When combining dry and
wet ingredients, you may wish to moisten ingredients
on Speed 1 or 2, then turn to the desired mixing speed.
• Use the mixing speed that is recommended in the
recipe. Use the handy mixing guide on the speed
control dial of the mixer to help you find the correct
speed to use.
• If times are specified in the recipe, use them! BE
CAREFUL NOT TO OVERMIX. Overmixing can
cause the mixture to become very tough.
• Should an object, such as a spatula, fall into the bowl
while the mixer is operating, turn the mixer OFF
immediately. Then, remove the object.
• Remove beaters and place in sink for easy clean-up.
• When preparing your favorite dish, DO NOT exceed
3 1 /
2
cups of flour in any recipe.
hints
Helpful Hints
To Order additional ACCESSORIES,
CALL 1-800-458-8407.
DESCRIPTION MODEL NO.
Dough Hooks 4964
Beater 4950
Large Glass Bowl
4938
Small Glass Bowl 4939
Large Stainless Steel Bowl 4951
Small Stainless Steel Bowl 4952
9
EJECTING THE BEATERS OR DOUGH HOOKS
After you’ve finished mixing, turn the speed control
dial to OFF and unplug the electric cord from the
electrical outlet. Push the ejector button located near
the handle to remove beaters or dough hooks.
Scrape excess batter off the beaters using a rubber or
plastic spatula. Do not strike beaters on the rim of
the bowl.
CLEANING YOUR MIXER
To clean the mixer, wipe the mixer head, stand and
turntable with a damp cloth, then dry. DO NOT
IMMERSE THE MIXER HEAD OR STAND IN
WATER. Avoid the use of abrasive cleaners, as they
may mar the finish of the mixer.
Wash the beaters and bowls in hot, soapy water after
each use. Rinse thoroughly and dry. Beaters and
bowls may also be washed in an automatic
dishwasher.
STORING YOUR MIXER
Store the mixer in a dry location, such as on a
countertop or table top, or in a closet or cupboard.
Insert the beaters into the proper sockets. Place the
dough hooks in the mixing bowl.
Store the bowl(s) on the turntable. The beaters will
help hold the bowl in position. Wind the electric cord
into a coil, secure it with a twist fastener.
MAINTENANCE
The motor of your stand mixer has been carefully
lubricated at the factory and does not require any
additional lubricant. Other than the recommended
cleaning, no further user maintenance should be
necessary.
Return the mixer to the nearest Authorized Sunbeam
Service Center for servicing or repairs.
cleaning
Caring For Your Mixer
8
SUN400_2377_StandMxr_mech 3/14/02 11:38 AM Page 14