SUPER MICRO Computer Supero SC512 - Manual (Page 55)

6-9
Chapter 6: Rack Installation
Mid-Mount Telco Rack
The SC512.supports Telco rack installation. The SC512 chassis compact design
allows the chassis to be installed into a Telco rack without the use of rails.
Installing the Chassis into a Rack in Mid-Mount Position
Instaling into a Mid-Mount Position Rack
If it is necessary to install the chassis in a mid-mount Telco rack, remove the 1.
chassis rails and the chassis ears (if the ears are installed at the front of the
chassis).
Locate the three screw holes in the middle of the chassis and secure the ears 2.
to the chassis with three flat head screws. Make sure the screws are secure,
but do not over tighten the screws.
Figure 6-6: Moving the Chassis Ears for Telco Rack Installation
Flat head
M4 x 4 mm
[0.157]
RAIL
Round head
M4 x 4 mm
[0.157]
Flat head
M5 x 12 mm [0.472]
Washer for M5
DVD-ROM CD-ROM FLOPPY DRIVE
Flat head
6-32 x 5 mm
[0.197]
Pan head
6-32 x 5 mm
[0.197]
Round head
3 x 5 mm
[0.197]
Pan head
6-32 x 5 mm
[0.197]
M/B
Flat head
6-32 x 5 mm
[0.197]
HARD DRIVE
Thumb screw
6-32 x 5 mm [0.197]
M/B standoff
6-32 to 6-32
M/B STANDOFF
M/B (CPU) standoff
M5 to 6-32
Round head
2.6 x 5 mm
[0.197]
Place chassis
ears here