SUPER MICRO Computer Supero SC512 - Manual (Page 33)

5-3
Chapter 5: Chassis Setup and Maintenance
5-4 Installing Hard Drives
Installing a Hard Drive
Before adding a hard drive, you must remove the DVD-ROM/CD-ROM drive.
Open the chassis cover. 1.
If you have not already done so, remove the fan tray. For more information on 2.
removing the fan tray, see the Maintenance section located at the end of this
chapter.
Remove the CD-ROM drive. To do this, remove the two screws holding the 3.
drive in place. One screw is external. The other is internal.
Figure 5-2: Removing the CD-ROM Drive to Access the Hard Drive
Remove these screws
DVD-ROM/CD-ROM
Drive
Flat head
M4 x 4 mm
[0.157]
RAIL
Round head
M4 x 4 mm
[0.157]
Flat head
M5 x 12 mm [0.472]
Washer for M5
DVD-ROM CD-ROM FLOPPY DRIVE
Flat head
6-32 x 5 mm
[0.197]
Pan head
6-32 x 5 mm
[0.197]
Round head
3 x 5 mm
[0.197]
Pan head
6-32 x 5 mm
[0.197]
M/B
Flat head
6-32 x 5 mm
[0.197]
HARD DRIVE
Thumb screw
6-32 x 5 mm [0.197]
M/B standoff
6-32 to 6-32
M/B STANDOFF
M/B (CPU) standoff
M5 to 6-32
Round head
2.6 x 5 mm
[0.197]