Soundstream Technologies Picasso - Manual (Page 4)

1.
2.
3.
4.
5.
a.
9.
10.
11.
12.
13.
14.
15.
16.
17.
19.
KEY TO
Power LED Indicates amplifier power.
Clip indicators Channels 1 2; Indicates the signal output level is too high
and the output stage of the amplifier is clipping.
Left Channel Balanced/Unbalanced input Selector Channel 1; Select
“BALANCED” to use the 6 pin Balanced signal input. Select “UNBALANCED” to
use the RCA signal inputs.
Right Channel Balanced/Unbalanced input Selector Channel 2; Select
“BALANCED” to use the 6 pin Balanced signal input. Select “UNBALANCED” to
use the RCA signal inputs.
Clip Indicators Channels 3 4; Indicates the signal output level is too high
and the output stage of the amplifier is clipping.
Channels Input Select Selectable inputs from internal (from channels
or external (from channels local balanced or RCA Inputs).
Left Channel Balanced/Unbalanced input Selector Channel 3; Select
“BALANCED’, to use the 6 pin Balanced signal input. Select “UNBALANCED” to
use the RCA signal inputs.
Right Channel Balanced/Unbalanced input Selector Channel 4; Select
“BALANCED,, to use the 6 pin Balanced signal input. Select “UNBALANCED” to
use the RCA signal inputs.
RCA Inputs Channels 3 4; Right and Left channel RCA (Unbalanced)
inputs.
Balanced Signal input Connector Channels 3 4; 6-Pin Balanced input
connector for use with the Soundstream Balanced Line Transmitter.
Input Levels Channels 3 & 4; Independent Left and Right input level controls.
Speaker Connection Terminal Speaker connections for Ch’s 3 4.
RCA Inputs Channels 1 2; Right and Left channel RCA (Unbalanced)
inputs.
Balanced Signal input Connector Channels 1 2; 6-Pin Balanced input
connector for use with the Soundstream Balanced Line Transmitter.
input Levels Channels 1 & 2; Independent Left and Right input level controls.
Speaker Connection Terminal Speaker connections for Channels 1 2.
REMOTE Remote turn-on input from the head unit. Accepts
GND Main ground connection. Bolt to a clean chassis point in the vehicle,
Connected to a fuse or circuit breaker, then to the battery’s positive
terminal
FUSE Main power supply fuse. Warning: Replace only with the same value
fuse!
Stereo/Bridged Mono Switch Channels 1 2; Select “Bridge” for bridged
mono operation (use right channel input). Select “Stereo” for two-channel
operation.
Stereo/Bridged Mono Switch Channels 3 4; Select “Bridge” for bridged
mono operation (use right channel input). Select “Stereo” for two-channel
operation.
TOP VIEW FRONT VIEW BOTTOM VIEW