Sony RM-VL710 - Manual (Page 28)

28
Executing a Series of Commands
— System Control Functions
(continued)
Tips for programming the
System Control functions
The following information helps
you to program a consecutive
operation steps.
About the order of operation
steps
Some of the components may not
accept consecutive remote control
signals. For example, a some TVs
generally may not react respond to
the next signal right after the
Power-on signal. So, a series of
commands such as TV Power-on
and input select may not work
properly.
In this case, insert other signals to
other components like such as in
the example below:
TV Power-on
tVCR Power-ont
VCR playback tTV input select
To clear programmed
commands
1
Press and while holding
SET, press and hold for
more than 3 seconds the
SYSTEM CONTROL button
you want to clear.