SpectraLink NetLink e340 - Manual (Page 55)

SpectraLink Corporation Configuration and Administration—NetLink e340/i640 Wireless Telephone
Cisco CallManager and IP Phone 7960 Emulation
72-1082-02-F.doc Page 55
Message Description Action
No ESSID Attempted to run site survey application
without an ESSID set.
Let handset come completely up.
Statically configure an ESSID in the Admin
menu.
No Func Code Handset software download files are
incorrect or corrupted
Reconfigure the handset to gain access to
the WLAN and download new code.
No Host IP The handset is configured for “static IP” (as
opposed to “use DHCP”) and no valid host IP
Address (the handset’s IP Address) has been
entered.
Enter a valid IP Address in the
configuration settings or change to “use
DHCP”.
No IP Address Invalid IP Check the IP Address of the handset and
re-configure if required.
No SVP IP The handset is configured for “static IP” (as
opposed to “use DHCP”) and no valid
NetLink SVP Server address has been
entered.
Enter a valid NetLink SVP server IP Address
in the configuration setting or change to
“use DHCP.”
No SVP Response
yyy.yyy.yyy.yyy
y…y = SVP Server IP address
Handset has lost contact with the SVP Server.
This may be caused by bad radio reception
or a problem with the NetLink SVP Server.
The handset will keep trying to fix the
problem for 20 seconds, and the message
may clear by itself. If it does not, the
handset will restart. Report this problem to
the system administrator if it keeps
happening.
No SVP Server Handset can’t locate SVP Server IP Address configuration of NetLink SVP
Server is wrong or missing.
SVP Server is not working Check error status screen on NetLink SVP
Server.
No LAN connection at the SVP Server Verify NetLink SVP Server connection to
LAN.
No Net Access Cannot authenticate / associate with AP Verify the AP configuration.
This indicates any of the following:
No radio link Verify that the AP is turned on.
No Net Found
No ESSID – Autolearn not supported (or)
Incorrect ESSID
Verify the ESSID of the wireless LAN and
enter or Autolearn it again if required.
Out of range Try getting closer to an AP. Check to see if
other handsets are working within the
same range of an AP. If so, check the
ESSID of this handset.
Incorrect WEP settings Verify that all the WEP settings in the
handset match those in the APs.
Incorrect Security settings Verify that all the Security settings in the
handset match those in the APs.