SpectraLink NetLink e340 - Manual (Page 24)

SpectraLink Corporation Configuration and Administration—NetLink e340/i640 Wireless Telephone
Cisco CallManager and IP Phone 7960 Emulation
72-1082-02-F.doc Page 24
If you have an OAI Gateway installed in your system, OAI may be optionally
enabled in each handset. You may select whether the handset should attempt to
connect to the SpectraLink OAI Gateway by choosing either the Enable or Disable
options in this menu.
If OAI is enabled, and an OAI IP address is available to the handset (either via
DHCP or Static IP configuration), the handset will communicate with the OAI
Server at power on, and periodically while it is powered on. If you don’t have a
SpectraLink OAI Gateway installed at your site, you should disable the OAI feature
to preserve network bandwidth and battery life.
Diagnostics
Run Site Survey
The Site Survey mode is activated by selecting this option. Site survey starts running
immediately upon selecting this option. See the Diagnostic Tools section for more
information about Site Survey.
Diagnostics Mode
See the Diagnostic Tools section for a detailed explanation of the Diagnostics Mode
options.
Syslog Mode
See the Diagnostic Tools section for a detailed explanation of the Syslog Mode
options.
Restore Defaults
The Restore Defaults option will set all user and administrative parameters except
License Options to their factory defaults.
4.2 User-defined Preferences
The following user-defined preferences are also covered in the NetLink e340/i640
Wireless Telephone user guide. The system administrator can refer to this list for
more information about customizing handset settings.
To configure the following options, the handset must acquire the system (no error
message may display) and be at the extension display. This is the standby state. While
in the standby state, press and hold FCN briefly to open the user options menu. Use
the following keys to display and select options:
Up/Down buttons: Display previous/next menu item.
Select button: Selects the menu item or option.
OK softkey: Selects the menu item or option.
Save softkey: Saves the entry.
Bksp softkey: Backspaces to allow editing of entry.
Cncl softkey: Cancels edit and return to previous menu level.
Up softkey: Returns to previous menu level.
Exit softkey: Exits the menu (at the top level).
End Call key: Exits to standby state (from any level).