Operation – Samsung CM929B User Manual
Page 12
12
Operation
Reading each Memory Program’s Cycle
Counter
1
Press the Check button.
The display will be cleared.
2
Press the
Start
button, then any
Number
button, from 1 to 20. The
number of cycles for that particular Memory Program will be
displayed. The cycle count is displayed in units of 10. For example,
if Memory Program 5 has been used 100 times, the display will
show “10”.
As the display uses units of 10, the cycle counts are approximate. The
cycle count displayed increases every ten cycles. For example, if the
cycle count were 90-99, “9” would be displayed, The “9” would change to
“10” on the 100th cycle. The cycle counter function has a limit of 99,990
cycles. Once that number is exceeded, the cycle counter will
automatically clear and start again from “0”.
3
After one second, the display will clear automatically. If you want to
check the cycle count of other Memory Programs, just enter the
Memory Program numbers.
4
Press the
Stop/Clear
button to exit the Checking mode.
Resetting the Memory Program Cycle Counter
1
Clear all operations by pressing the
Stop/Clear
button.
The display will show “ : 0 “ or the present time (If the time is set).
2
Press Number “ 0 “ and the
Auto Defrost
button at the same time.
The Microwave will emit a Beep sound confirming the reset
operation. The display will show “ : 0 “ or the present time (If the time
is set).
Setting the Sound
1
Press the
Sound
button to adjust sound volume. The basic sound
volume is "LO". Press the
Sound
button repeatedly, to change the
volume in the following order - MED, HI, OFF, LO.
2
Press the
Start
button to exit the Sound mode.
The display will show “ : 0 ” or the present time (If the time is set).
Indicator
Sound
HI
Loud
MED
Middle
LO
Low
Blank
Off
jt`Y`iniUGGwGXYGG{ SGuGYWSGYWWXGGXWaZZGht