Woodstock W1679 - Manual (Page 17)

ASSEMBLY
-15-
Figure 18. Attach belt guard to stand
with the hex bolt.
Belt Guard
Attach the belt cover to the cabinet stand with
the
5 ⁄
16
"-18 x 2 1 ⁄
2
" hex bolt as shown in Figure
18.
Knife Gauge
The knife gauge consists of a steel rod, two
adjuster arms and two E-clips.
To assemble the knife gauge:
1. Insert the steel rod through each adjuster
arm.
2. Snap the E-clips into the grooves at the ends
of the steel rod so your assembly looks like
the knife gauge shown in Figure 19.
See page 16-17 for usage instructions.
Control Pedestal
1. Mount the control pedestal to the back of
the cabinet stand as shown in Figure 20.
2. Secure the control pedestal with the (4)
5 ⁄
16
" hex nuts and (4) 5 ⁄
16
" washers from the
hardware bag.
Figure 19. Knife setting gauge.
Figure 20. Mounting pedestal switch to stand.
Make sure that your
machine is unplugged
during all assembly pro-
cedures! If this warning
is ignored, serious per-
sonal injury may occur.