Samsung SWV-1200F - Manual (Page 6)

Installing the Washing Machine
4 SAMSUNG Washing Machine Owner’s Instructions
Connecting the water supply hose
The water supply hose must be connected to the washing machine at one end and to the water faucet at
the other. Do not stretch the water supply hose. If the hose is too short and you do not wish to move the
water faucet, replace the hose with a longer, high pressure hose.
To connect the water supply hose:
1. Connect the cold water supply hose(Blue) fitting with the L-shaped arm to the cold water supply
intake(Blue) on the back of the washing machine and hand tighten.
2. Connect the other end of the cold water supply hose to your sink’s cold water faucet and tighten it
by hand. If necessary, you can reposition the water supply hose at the washing machine end by
loosening the fitting, rotating the hose, and retightening the fitting.
Option :
1. Connect the hot water supply hose(Red) fitting with the L-shaped arm to the hot water supply
intake(Red) on the back of the washing machine and hand tighten.
2. Connect the other end of the hot water supply hose to your sink’s hot water faucet and tighten it by hand.
3. If you want to use only cold water, use Y-piece.
Positioning the drain hose
The end of the drain hose may be positioned in three ways:
Over the edge of a sink
The drain hose must be placed at a height of between 60 and 90 cm. To keep the drain hose spout bent,
use the supplied plastic hose guide. Secure the guide to the wall with a hook or to the faucet with a piece
of string to prevent the drain hose from moving.
In a sink drain pipe branch
The drain pipe branch must be above the sink siphon so that the end of the hose is at least 60
cm above the ground.
90 cm
60 cm
a
b
a
b
c
1.Remove the adaptor
from the water
supply hose.
2.First,using a "+" type screw driver,
loosen the four screws on the
adaptor. Next,take the adaptor and
turn part(b) following the arrow for
gap about 5mm between them.
3. Connect adaptor to the water tap by
tightening the screws firmly.
Then,turn part (b) following the
arrow and put (a) and (b)together.
5. Connect the other end of the water supply
hose to the inlet water valve at the top of
the washer. Screw the hose clockwise all
the way in.
● If the water tap is a screw type,assemble a
water supply hose that fits to the tap as
shown.
4. Connect the water supply hose to the
adaptor. Pull down the part (c) of the water
supply hose. When you release part (c) the
hose is automatically connects to the
adaptor making a 'click' sound.
NOTICE After completing connection,if water leaks from the hose,then repeat the same steps. Use the most conventional type of faucet
for water supply. In case the faucet is square or too big,remove the spacing ring before inserting the faucet into the adaptor.
Connecting the water supply hose (Option)
SWV1200F-00163A-dw 9/9/02 11:37 AM Page 4