Sunbeam SR3200 - Manual (Page 7)

7
Using the shot of steam
The shot of steam can be used whether DRY
or STEAM ironing when the temperature dial
is set to any temperature above the two dot
(••) setting.
1. Ensure the tank is at least ¼ full of
water.
2. Select the desired temperature and wait
until the thermostat light goes out.
3. Press the shot of steam button several
times with the iron on the soleplate to
prime the pump.
NOTE: If the tank has run dry, it may be
necessary to re-prime the pump after filling
the iron with water.
Using the spray mist
The spray mist can be used whether dry
or steam ironing to pre-dampen hard to
iron fabrics.
1. Ensure the tank is at least ¼ full of
water.
2. Press the spray button during ironing to
release a fine mist from the spray nozzle.
Using your Sunbeam Pro Steam II Iron (continued)
After each use
1. Turn the STEAM/DRY dial to DRY.
2. Turn the power off and remove the plug
from the power outlet.
3. Empty any remaining water from the
water tank.
4. Allow the iron to cool before winding the
cord around the built-in cord wrap.
Storage
Always store the iron on its heel rest.
NOTE: Do not store the iron with the soleplate
facing down, or in the carton.
Cleaning
To clean the exterior of your iron, wipe over
with a damp soft cloth and wipe dry.
Caution: Do not use harsh abrasives, chemical
cleaners or solvents to clean the exterior of
your iron as these will damage the surface.
Cleaning the removable steam valve
To remove the steam valve, turn the STEAM/
DRY dial to (•), so that the steam valve pops
up. Gently scrub the tip of the valve with a
steel wool soap pad moistened in warm water.
Rinse and dry with a clean cloth. Replace the
steam valve and turn clockwise to lock into
positon.
To clean the steam holes
To remove build up from the steam holes which
may affect steam performance, use a cotton
wool tip moistened in methylated spirits.
Cleaning the Teflon® Select non-stick soleplate
(SR3200)
The non-stick coating reduces sticking of
fabrics and starches to the soleplate. Do not
iron over sharp objects such as buttons, studs
and zippers, as these will scratch the surface.
Wipe the soleplate with a damp soft cloth
after each use. If polyester has burnt to the
soleplate, iron a damp cotton cloth while hot.
Caution: Do not use scouring pads, abrasives
or harsh cleaners to clean your Teflon ® Select
non-stick soleplate, as these will scratch and
damage the surface.
Cleaning the Polished Aluminium soleplate
(SR3100)
Rub gently with a stainless steel soap pad
moistened in warm water. Wipe dry.