beautypg.com

Sunbeam’s safety precautions – Sunbeam SR3200 User Manual

Page 3

background image

3

Sunbeam’s Safety Precautions

3

Sunbeam’s Safety Precautions

Sunbeam are very safety conscious when

designing and manufacturing consumer

products, but it is essential that the product

user also exercise care when using an

electrical appliance. Listed below are

precautions which are essential for the safe
use of an electrical appliance:

• Read carefully and save all the instructions

provided with an appliance.

• Always turn the power off at the power outlet

before you insert or remove a plug. Remove by

grasping the plug – do not pull on the cord.

• Turn the power off and remove the plug

when the appliance is not in use and before

cleaning.

• Do not use your appliance with an extension

cord unless this cord has been checked and

tested by a qualified technician or service

person.

• Always use your appliance from a power outlet

of the voltage (A.C. only) marked on the

appliance.

• This appliance is not intended for use by young

children or infirm persons unless they have been

adequately supervised by a responsible adult to

ensure that they can use the appliance safely.

• Never leave an appliance unattended while in

use.

• Young children should be supervised to ensure

that they do not play with the appliance.

• Do not use an appliance for any purpose other

than its intended use.

• Do not place an appliance on or near a hot

gas flame, electric element or on a heated

oven. Do not place on top of any other

appliance.

• Do not let the power cord of an appliance

hang over the edge of a table or bench top or

touch any hot surface.

• For safety reasons and to avoid maintenance

by unskilled persons, some appliances are

‘sealed’ using tamperproof screws. Such

appliances should always be returned to the

nearest Sunbeam Appointed Service Centre for

adjustment or repair if required.

• Do not operate any electrical appliance with

a damaged cord or after the appliance has

been dropped or damaged in any manner. If

damage is suspected, return the appliance

to the nearest Sunbeam Appointed Service

Centre for examination, repair or adjustment.

• For additional protection, Sunbeam

recommend the use of a residual current

device (RCD) with a tripping current not

exceeding 30mA in the electrical circuit

supplying power to your appliances.

• Do not immerse the appliance in water or any

other liquid unless recommended.

SAFETY PRECAUTIONS FOR YOUR IRON
• Do not leave a hot iron within reach of

children. If they come into contact with a hot

iron it could lead to serious burns.

• Iron only on an ironing board.
• An iron takes approximately 30 minutes to

cool down. Allow the iron to cool completely

before storing.

• Do not wind the cord around the soleplate

while the iron is still hot.

• Do not leave the iron unattended while it is

plugged into the power outlet.

• Always unplug the iron from the power outlet

before filling or emptying the water tank.

If you have any concerns regarding the performance and use of your appliance,

please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line.

Ensure the above safety precautions are understood.

This manual is related to the following products: