beautypg.com

Shure ULX Wireless System User Manual

Page 22

background image

22

ULX1 Transmitter Output

Actual Impedance:

50 Ω

Nominal Output Level:

20 mW

Maximum Output Level:

30 mW

Pin Assignments:

Shell = Ground Center = Signal

ULX2 Transmitter Input

Input Configuration:

Unbalanced, active

Actual Impedance:

20 kΩ

Maximum Input Level:

10 Vp–p (12 dBV) for 1% THD at minimum gain setting using 1 kHz

signal.

ULX2 Transmitter Output

Actual Impedance:

50 Ω

Nominal Output Level:

20 mW

Maximum Output Level:

30 mW

Pin Assignments:

Shell = Ground Center = Signal

ULXS4 and ULXP4 Receiver Input

Connector:

Antenna

Power Input

Connector Type:

BNC

IEC 320

Actual Impedance:

50 Ω

––

Nominal Input Level:

–95 to –30 dBm

15 Vdc

Maximum Input Level:

+6 dBm (–20 dBm recommended)

18 Vdc

Pin Assignments:

Shell = Ground Center = Signal

IEC Standard

Voltage for Remote Power:

12 Vdc, 150 mA maximum

––

ULXS4 and ULXP4 Receiver Output

Connector:

High Z Audio

Low Z Audio*

Output Configuration:

Unbalanced (1/4 in.)

Balanced (XLR)

Actual Impedance:

3 kΩ

22 Ω

Nominal Input Level:

––

––

Pin Assignments:

Tip = Hot Ring/ Sleeve = Gnd

1 = Ground

2 = Hot

3 = Cold

Voltage/Current/Phantom

Power Protection?

Yes

Yes

*Output Level: Microphone Level = Line Level – 20 dB

Transmitter Audio Polarity

Positive pressure on microphone diaphragm (or positive voltage applied to tip of WA302 phone plug) produces positive
voltage on pin 2 (with respect to pin 3 of low impedance output) and the tip of the high impedance 1/4-inch output

Transmitter Gain Adjustment Range

ULX1: 25 dB

ULX2: 25 dB

Receiver Audio Output Level (±38 kHz deviation, 1 kHz tone)

XLR connector (into 600 ohm load): +3.9 dBV (line), –17 dBV (mic)
1/4 inch connector (into 3000 ohm load): –2 dBV

Impedance

ULX1 (input): 1 Megohm ULXS4, ULXP4 (output): 50 ohms at line level; 2000 ohms at mic level

Modulation

±38 kHz deviation compressor-expander system with pre- and de-emphasis.

RF Power Output

ULX1, ULX2: 30 mW maximum

Dynamic Range

>100 dB, A-weighted

RF Sensitivity

1.26 μV for 12 dB SINAD (typical)

Image Rejection

80 dB typical

Spurious Rejection

75 dB typical