beautypg.com

Spin Master Havoc Stinger User Manual

Page 2

background image

HOW TO INSTALL YOUR BATTERIES

HOW TO CHARGE YOUR HAVOC STINGER™

BATTERY INSTALLATION – CONTROLLER/CHARGER

1. Use a Phillips head (Cross-Head) screwdriver to loosen the screws on the battery case anti-clockwise (pic.1).
2. Put 6 AA size batteries in the battery compartment as per the polarity shown inside (pic.2).
3. Tighten the screw in clockwise (pic.3).

HOW TO FLY YOUR HAVOC STINGER™

1. SET THE BAND ON YOUR CONTROLLER:

2. TRIMMING YOUR HELICOPTER:

To do this, you must check which frequency letter your helicopter is set at.
Turn over the helicopter and you will find a letter (A,B,C) on the bottom.
Set the band selector on your controller to the same letter by moving the horizontal switch.

1. The helicopter will have 5-6 minutes of flight time after a 20-30 minute charge.
2. Before you recharge the battery, wait 10-15 minutes to let the battery cool down.

3. CHOOSE AN IDEAL FLIGHT ENVIRONMENT

Choose the place which meets the following conditions:
1. Indoor environment with calm air-condition. Beware of the air circulation from the air-conditioner.
2. Space area: It is recommended to have space area over 10 ft (W) x 16.5 ft (L) x 8 ft (H).
3. Safety area: It is highly recommended that there is no electric fan, air-conditioner, reading lamp or other dangerous objects to flying.

Things to remember:

Gently push the throttle up to raise your helicopter 1.5 ft to 3.25 ft high off the ground.

If your helicopter turns CLOCKWISE, continue to push the LEFT side of the trim REPEATEDLY until the turning stops
and the helicopter flies straight.

If your helicopter turns COUNTER CLOCKWISE, continue to push the RIGHT side of the trim REPEATEDLY until the turning stops
and the helicopter flies straight.

pic.1

pic.3

pic.2

Pull out the cover
and take out the
charging wire.

Insert the charge plug into
the socket on the side of the
helicopter.

The green LED will light up when
charging. Once
completed it will
turn OFF. Pull
the plug out from
the side of the
helicopter.

STEP ONE

STEP TWO

STEP THREE

STEP FOUR

Keep turning clockwise

or

Spiral clockwise

Keep turning counter clockwise

or

Spiral counter clockwise

STEP

ONE

STEP

TWO

STEP

THREE

NOTE: Your Havoc Stinger™ loses
its trim EVERY time you turn it off.
So remember these helpful tips to
stabilize it every time!

ON

OFF

CHG

Turn off the power to the
helicopter located on the side
of the helicopter.