Sirius Satellite Radio SR-100C - Manual (Page 9)

99 SIRIUS/DBS Signal Combiner/Splitter Installation Guide
Installation Procedure
Once you have determined where in your system you will be mounting the
SIRIUS/DBS Signal Combiner/Splitter, you can proceed with the installation. If
you have not yet mounted your SIRIUS outdoor antenna, do that first, carefully
following the installation instructions included with the outdoor antenna. For ease
of installation, mount the outdoor antenna on the support bracket for the satellite
TV dish as shown in the antenna installation instructions, however, the SIRIUS
antenna may be mounted anywhere within 30 feet of the satellite TV dish.
Once the SIRIUS outdoor antenna has been mounted, follow these steps to install
the SIRIUS/DBS Signal Combiner/Splitter.
Outdoors:
1. Install the Signal Combiner (shown as A on page 3) in a convenient location
within 3 feet of the satellite TV dish using the provided screws.
2. Disconnect the cable which brings the signal from the
satellite TV dish and connect that cable to the Signal
Combiner connector labeled COMBINED OUT.
Depending upon where you are installing the SIRIUS/
DBS Signal Combiner/Splitter in your system, this cable
may be connected to the LNBF at the satellite dish, or
connected to a multiswitch, or connected to a signal
splitter, etc. When disconnecting this cable, make a note
of where it was connected for the next installation step.
COMBINER
SPLITTER
MULTISWITCH
SIRIUS
RECEIVER
RECVR/TUNER
COMBINER
SPLITTER
MULTISWITCH
SIRIUS
RECEIVER
LEGACY
RECVR/TUNER
RECVR/TUNERs RECVR/TUNERs
DISHPRO
ADAPTER
DISH NETWORK ONLY:
COMBINER
COMBINED OUT
DBS IN SIRIUS IN