beautypg.com

Smeg KSEI60S User Manual

Page 12

background image

This appliance is marked according to the European

directive 2002/96/EC on Waste Electrical and Electronic

Equipment (WEEE). By ensuring this product is disposed

of correctly, you will help prevent potential negative

consequences for the environment and human health,

which could otherwise be caused by inappropriate waste

handling of this product.

The symbol

on the product, or on the documents

accompanying the product, indicates that this appliance

may not be treated as household waste. Instead it shall be

handed over to the applicable collection point for the

recycling of electrical and electronic equipment. Disposal

must be carried out in accordance with local environmental

regulations for waste disposal.

For more detailed information about treatment, recovery and

recycling of this product, please contact your local city

office, your household waste disposal service or the shop

where you purchased the product.

Operation

The control panel is provided with a suction power selection

switch and cook top light switch.

Located on the side of the lamp panel.

Warning! Some models are provided with automatic on/off

switch via opening and closing the vapour collector.

Use the higher suction speed for higher concentration of

cooking vapours. It is recommended to operate the cooker

hood suction 5 minutes prior to cooking and leave it in

operation for approximately 15 minutes after cooking.

Maintenance

Prior to any maintenance operation ensure that the

cooker hood is disconnected from the electrical

outlet.

Anti-grease Filter

Traps cooking grease particles.

If situated inside the grill support, it may be one of

the following types:

Paper filter must be replaced once a month or sooner, if

coloured on the upper side, when the coloration is visible

through the grill holes.

Sponge filter should be washed in soapy water monthly

and replaced every 5/6 washes.

Metallic filter must be cleaned once a month by hand using

non abrasive detergents or in dishwasher on low

temperature and short cycle.

When washed in a dish-

washer, the grease filter may discolour slightly, but this

does not affect its filtering capacity.

To access the grease filter (Fig. 7,V) open the suction grill

via the releases (Fig.2,H1) and loosen from locks (Fig.

7,W).

Some models are provided with anti-grease filter incorporated

in the suction grill, these should be removed from the

housing by pulling the handles upwards and sliding out

(Fig.2,H2-H3-H4), wash these filters as with metallic filters.

Carbon Filter (Filter Version only)

The active carbon filter is not washable nor reusable.

Traps unpleasant cooking odours.

It is mounted inside the cooker hood covering the motor

protection grill – it may be one of the following types:

Rectangular ( it should be replaced every 6 months):

position the filter (Fig.8,X) inside the frame.

Hook the filter first in the upper part (Fig.8,Y1) then secure

in the lower section with the two hooks provided on the filter

(Fig.8,Y2).

Circular (it should be replaced every 4 months)-

Bayonet insert position the filter in the centre (if necessary

use the hooks (Fig.8,Z) for centring the filter) covering the

motor protection grill ensuring that the reference (Fig.8,A1)

on the carbon filter corresponds with the reference (Fig.8,A2)

on the conveyor, turn clockwise; for dismounting the carbon

filter carry out the instructions in reverse.

The procedure for mounting and dismounting the carbon filter

for models with one or two carbon filters is identical.

Cleaning: The cooker hood should be cleaned regularly

internally and externally.

For cleaning use a cloth moistened with neutral liquid

detergents. Avoid abrasive detergents.

Failure to carry out the basic standards of the

cleaning of the cooker hood and replacement of the

filters may cause fire risks. Therefore we recommend

oserving these instructions.

Lamp replacement : Remove the suction grill (or directly

open the lamp area if provided with release hooks D1-Fig.8)

to access the lamp area.

Firstly check that the lamps are well cooled prior to replacing

them.

Remove the damaged lightbulb and replace with an

oval incandescent lightbulb max. 40W E14 or PL lamp

of 11W (cooker hood with one lightbulb) or 9 W (cooker

hood with two lightbulbs).