Snapper Front Implement Lift Kit 1691195 - Manual

INSTALLATION FRONT IMPLEMENT KIT
INSTRUCTIONS
MFG. NO. 1691195
A
WARNING
Stop the engine and remove key before
installing kit or making any adjustments.
NOTE: For tractor Mfg. No. 1691017 with serial num-
ber 1273 or lower, and tractor Mfg. No. 1601019 with
serial number 10400 and lower, it will be necessary to
replace the existing bracket support with part number
1676455 in order to install this kit.
NOTE: Make sure hydraulic wnnections are tight.
Where possible make connections using a vise before
installing parts on tractor.
Check kit parts against illustration and parts list on
pages 2 3.
2. Remove tractor hood to ease installation.
3.. See Figure 3. Remove the existing retaining rings.
Install the bushing (4) and lever (3). Install the curved
washers and retaining rings.
4. Disconnect hoses from existing valve. Note and mark
their positions. Remove the valve by removing nut
and bolt that holds the hydro fill tube.
5. Install the new valve using existing hardware and
new x 2 (28, figure 3). This longer
also secures hydro fill tube clamp. Use the
upper hole in the mounting plate for the new
screw as shown.
6. See figure 1. Connect the hoses to the new valve in
the same positions as on original valve. Connect the
right and left tubes (5 6, figure 3) as shown.
7, Route the front tubes (9 10, figure 3) under the
front brackets as shown in figure 2.
6. See figure 4. Assemble the plastic plugs retain-
ing rings bodies (14) and brackets (15 16).
Attach to tractor as shown in figure 3.
9. On right-hand side, bracket (16, figure 3)
using lockwasher (20) and nut (21).
On left-hand side, secure bracket (15) using same
hardware used to secure bracket for PTO idler
spring.
The PTO spring is under tension when
Installed.
Figure 1.
A. Lift Lever Support E. Hose
E-Ring F. Elbow
C. Tube, Right (Ref. E,
D. Tube, Left, (Ref. Fig. 1)
Figure 2. (Hood Removed)
A. Brackets
Figure 3.
A. Plugs Brackets
FORM 1701802