Sharp VIEWCAMZ VL-Z5E - Manual (Page 78)

Advanced Features
Playback
Advanced Features
68
AV-OUT
VIDEO
S-VIDEO
L-AUDIO-R (MONO)
:
Using the Camcorder
as a Converter
Available mode:
Tape Playback
You can use this camcorder to convert from
analog signal (e.g. video recorded on 8 mm
or Hi8 tapes) to digital signal.
Preparation
Connect the audio/video/S-video cable and
DV cable as shown below.
Note:
• See page 2 for how to open the terminal
cover.
P L A Y B A C K
A U D I O
A N L G D G T L
R E T U RN
S E T
O F F
O N
R O T A T E P B
O N A N L G D G T L
1
Set the camcorder to Tape Playback
mode, and make sure that playback is
stopped.
2
Press the DISPLAY button until the
mode screen appears.
3
Select “MENU”, then “EXECUTE” by
using the Operation button (see page
32).
4
Press l or m to select V, then
press the centre of the Operation
button.
5
Press l or m to select
“ANLGyDGTL”, then press the centre
of the Operation button.
6
Press l or m to select “ON”, then
press the centre of the Operation
button.
To DV terminal
To AV terminal
To DV terminal
DV cable (commercially available)
Playback
(analog equipment)
e.g. 8 mm or Hi8
camcorder
Black: To S-video output socket
Yellow: To video output jack
White: To audio output (L) jack
Red: To audio output (R) jack
Analog
signal
Audio/video/S-video cable (supplied)
Digital
signal
Recording
(digital equipment)
e.g. computer
The arrow shows the signal flow.