Sagem MY 302X - Manual (Page 12)

11
2. Getting started
2.2 Installing the SIM card
and the battery
Switch off your phone and
disconnect the charger.
The SIM card is inserted beneath
the phone’s battery.
Turn your phone over and
remove the rear cover. Press on
top and make it slide.
Slide the card along the base
beneath the retaining plate, with
the gold coloured sections facing
towards the phone and the cut-
off corner lined up to match the
drawing on the phone.
Place the battery by first
inserting the upper section into
the opening.
Replace the cover sliding it until
it locks.
PIN code
This is the personal code for your SIM card. You
may be asked to enter this code when the instruction:
Pin number ? appears after you switch on your
phone.
Enter the code of between 4 and 8 digits given
to you by your operator. These digits will not be
displayed on the screen for security reasons.
Press # or OK or to validate.
PIN2 code (*)
If one was given to you by your Operator, a second
PIN code provides secure access to certain functions.
5
Warning
If the wrong PIN code is entered three times in a row, the card
will be locked. To unlock your card:
- enter **05*
- enter the PUK code (Personal Unlocking Key) provided by
your Network Operator and validate,
- enter your PIN code and validate,
- enter your PIN code again and validate.
After 5 or 10 times (depending on SIM card type), the SIM card
will be permanently locked. Contact your Operator or your
Service Provider to obtain a new card.
The same procedure (entering 052) applies when the PIN-2
code is blocked (PUK 2 code).
MY_304X_EN-02.p65 28/12/01, 11:22 11