Sunbeam 6091 - Manual (Page 4)

• If the jar should turn during operation, skirt is loose. Switch OFF immediately and
tighten skirt assembly.
• Do not leave blender unattended while it is operating.
• To disconnect cord, turn the control to OFF, then remove the plug from wall outlet.
• If glass jar is chipped or cracked, do not use. It could break during operation.
• Do not use appliance for other than intended purpose.
s
peciaL
i
nstructions
• This appliance intended for household use only. Use for food or liquids only.
• This appliance is equipped with a polarized plug. This type of plug has one blade
is wider than the other. This plug will fit in a polarized outlet only one way. This is a
safety feature intended to help reduce the risk of electrical shock. If you are unable
to insert the plug into the outlet, reverse the plug. If it the plug should still fail to
fit, contact a qualified electrician to replace the obsolete outlet. Do not attempt to
defeat this safety purpose of the polarized plug by modifying the plug in any way.
• The length of the cord used on this appliance was selected to reduce the hazards of
becoming tangled in, or tripping over a long cord. If a longer cord is necessary an
approved extension cord may be used. The electrical rating of the extension cord
must be equal to or greater than the electrical rating of the blender (3.4 ampere).
Care must be taken to arrange the extension cord so that it will not drape over the
countertop or tabletop where it can be pulled on by children or accidentally tripped
over.
• If the blender blades lock and do not move, it will damage the motor. Do not use.
Call the toll-free customer service number for information.
• Do not place blender in the freezer filled with food or liquid. This will freeze and
damage the blade assembly, jar and motor.
saVe tHese instructions
MANTENIMIENTO DE SU LICUADORA
DE 10 VELOCIDADES
Cómo Limpiar la Licuadora
• Desenchufe la unidad del tomacorriente.
• Limpie la base del motor, el panel de control y el cable con un paño o
esponja húmedos. Para remover manchas difíciles, utilice un limpiador
suave, no abrasivo.
• Para limpiar el vaso, desenrosque la rosca inferior del vaso manteniéndolo
inclinado, de manera que la cuchilla no se salga mientras retira la rosca.
• Una vez que haya retirado la rosca inferior, retire la cuchilla por la parte de
las láminas más bajas.
• Retire cuidadosamente el anillo sellador de la parte donde están
localizadas las aspas de la cuchilla.
• Lave con cuidado la cuchilla, la rosca inferior, el anillo sellador, el vaso
y la tapa con agua tibia y jabonosa. Enjuáguelos y séquelos
generosamente. No empapar. No lave la cuchilla, la rosca, el anillo de
goma o la tapa en el lavaplatos automático.
• Vuelva a colocar la rosca inferior junto con la cuchilla y el anillo de goma
en el vaso de vidrio de su licuadora. Hágalo inclinando un poco el vaso
de manera que la cuchilla entre por la parte de las aspas superiores
dentadas. Mueva como sea necesario para que entren las otras láminas.
• Vuelva a enroscar en el vaso la rosca inferior junto con las otras piezas
ensambladas y coloque el vaso sobre la base de su licuadora.
7